Cooling Towers

Adiabatic Dry Cooling Towers

Adiabatic products are air-cooled coolers or condensers with adiabatic pre-coolers. Before the fan draws the ambient air through the finned coil, the air is pre-cooled adiabatically when traversing a humidification pad. This evaporates the water in the air, thus boosting the cooling capacity.

Round Shape Cooling Towers

ICT (Induced Draft Counter flow Cooling Tower) Round shaped or popularly known as bottle type are designed to cool industrial re-cycled process water from temperature of 50 degrees to temperature of 4 plus the prevailing Wet Bulb temperature of the region.

Square Shape Cooling Towers

ICT-square shaped towers cool the re-cycled water. The towers blend easily with architectural surroundings, giving a unique aesthetic appearance.

Wooden Cooling Towers

This rugged war horse in our stables, incorporate multi blade, cast aluminum, adjustable pitch fan assembly driven by special T.E, IP-55 protected Geared Motor with low R.P.M and higher air discharge capacities.

Cross Flow Cooling Towers

The tower design incorporates a FRP distribution basin with number of flower type target nozzles in it and is located at the tower top.

Modular Cooling Towers

A modular cooling tower assembly is provided that comprises at least one cooling tower module having extendible legs capable of supporting the assembly when fully extended. When more than one cooling tower module is used in the assembly, adjacent modules are attached together at their respective frames.

Natural Cooling Towers

Devoid of either the fan or the fill media these towers are guaranteed for 100% savings in power & maintenance down time. The special aero dynamic designed FRP/GI louvers minimize spillage and evaporation losses.

Dry Cooling Towers

Dry cooling towers are in a single unit can be provided in capacities from 1000 kw to 1500 kw and they can be multiplexed to reach many thousand or kilowatts.

Closed Circuit Cooling Towers

Closed circuit cooling towers serving most of the grind buildings at affordable cost and not only saves the water as well power consummation and foot prints.

Plate Type Heat Exchangers

The plate heat exchanger is made of 2 frames and a number of plates that depend on the volume to be exchanged.

Shell and Tube Heat Exchangers

Shell and Tube heat exchangers are suitable for heat transfer fluids, lubricating oil, power pack oil and other process coolants. Models available in wide range.

Counter Flow Cooling Towers

Counter flow design cooling towers usually offer a smaller footprint than cross flow towers and allow maximum thermal performance out of each plan area. Counter flow towers also help minimize your pump head requirements.